All error codes
Mistake #1: Overheating the room
Mistake #2: Steam generator overheating
Mistake #3: Process Overheating
Mistake #4: Overpressure Error
Mistake #5: Sterilization pressure too low
Mistake #6: Sterilization temperature too low
Mistake #7: Too much pressure when drying
Mistake #8: Too many steam pulses / no water
Mistake #10: Room Heating Error
Error #11: Steam Generator Heating Error
Error #12: Pre-vacuum / output check failed
Mistake #14: Pressure on standby
Error #17: V3 Valve / HEPA Filter Error
Error #18: Pressure sensor error
Error #19: USB disk error / change disk
Mistake #20: Minimum Room Temperature
Error #21: Room temperature sensor failure
Error #22: Steam Generator Temperature Sensor Failure
Error #23: Process temperature sensor failure
Mistake #24: The autoclave is too cold
Error #31: Internal Flash Error
All messages
Overpressure on standby
Description of the problem
Overpressure in standby mode.
What can I do to solve the problem?
The reason for this error is that the hot sterilizer is left with the chamber closed (e.g. overnight). When the sterilizer cools down, a vacuum is created in the chamber, which causes a startup error. Wait for the device to automatically equalize the pressure – the message will disappear automatically.
